Elk Part Number: ELK-110v5
out of 5.0 based on
Shipping as low as $6.95
Availability: Ships in 3-5 Days
Your Price: $47.99 Qty
Choose from the following options:
Similar Items to Consider
The ELK-110 Voice "Talking" Driver features high quality digitally pre-recorded voice messages and loud attention getting siren sounds in an economical, low current draw, compact package. It features two input channels, bilingual voices (English and Spanish), and many unique options which allow it to be used with virtually any residential or commercial alarm installation. The voice messages and the siren alternately sound whenever one of the channels are activated.
The ELK-110 may be customized by use of on-board jumpers. For example: our MilliMiser option allows the already low current draw of the ELK-110 to be reduced even lower. This is ideal for controls with limited alarm output power. The ComboTrigger option allows controls which have a single alarm output and pulsing option to activate both the burglar and fire alarm sounds. The VolumeStep option is best described as the "peacekeeper", since it causes the siren sound to start at low volume, gradually increasing over 90 seconds to maximum volume. Also available is the ELK-55, a self contained voice siren.
Installer Friendly - Compact & Easy to Mount
Three Input Channels, Burglar, Fire, and Carbon Monoxide
Bilingual Voice - English and or Spanish, Siren Only, Speech Only, or Combined
MilliMiser Lowers Current Draw
ComboTrigger For Single Outputs
VolumeStep Slowly Increases Siren Volume
Temporal 3 Coded Fire Signal
Temporal 4 Coded CO Signal
Pre-Wired For Easy Installation
Lifetime Limited Warranty
Operating Voltage: 10 to 14 Volts DC
Current Draw: 1.25 Amps, (800 mA on MilliMiser setting), with one 8 Ohm speaker
Sound Level: 122 db @ 1 meter, 14 vdc, with one 8 Ohm speaker
New Model even better,
Submitted by Cliff Goff
The replacement model (ELK-110v5) now includes a third channel for CO. I am using it with 2 Ademco 746 speakers in series, and triggered by a 4204 module, connected to a Vista 20P. The voice samples are acceptable, and allow for the ability to NOT have a voice for a particular event. Very flexible in its configuration. Easily recommended. See the ELK website (http://www.elkproducts.com/_webapp_2981387/ELK-110_Voice_Driver_Module) for more details.
A definite attention getter!,
Submitted by Ciro Crespo
I used the module with Safemarts 30 watt speakerand was very impressed! Gripe: difficult to mount securely in the panel. Be prepared to make some plastic spacers.
This item has been added to your shopping cart.
ELK Voice Siren Driver Module Part # ELK-110v5
Don't show this message again. I understand SafeMart's DIY policy